Difference between revisions of "What is a SYSLINUX disk ?"
m (Minor additions and improvements.)
(Fixed two outdated links which still pointed to User:Scdbackup)
|Line 87:||Line 87:|
See also the articles about
See also the articles about
[[#Preparing_a_normal_disk|Preparing a normal disk]]
Revision as of 16:26, 12 March 2014
Throughout the SYSLINUX wiki, the term disk is used for a storage medium which can host a random-access read-write filesystem.
For SYSLINUX, frequently the filesystem is some variant of FAT, e.g. FAT32/16/12. SYSLINUX can also be installed on NTFS, and EXTLINUX supports some additional filesystems, such as ext2/3/4 and btrfs.
There are optical disc (not "disk") families of CD, DVD, and BD (Blu-ray). Optical media uses the ISO9660 filesystem, and can boot by means of "The El Torito" specification, which includes 3 alternative boot modes:
- floppy emulation (using SYSLINUX)
- hard disk emulation (using SYSLINUX)
- no emulation (using ISOLINUX)
In addition to real media, regular data files qualify as SYSLINUX disks if they get prepared with a supported filesystem, typically FAT. It can include MBR, or GPT, or otherwise be a "partitionless" media (e.g. floppy).
After its preparation, such a data file is called disk image. For booting it with real hardware, it usually has to be written onto a real storage device. e.g. onto a USB pen drive attached to a Linux system as /dev/sdX. (Make sure to use the right device address and to backup any valuable content of the pen drive before proceeding.)
One possible method to write "my_disk.img" to the "sdc" device is:
dd if=my_disk.img of=/dev/sdc conv=fdatasync
Nevertheless, there are occasions where disk image files are part of a boot process, without occupying a whole own storage device. Such case is out of the scope of this article.
Installing SYSLINUX on disk images under Linux
The following procedures refer to a disk image with MBR.
We need to know the start address of the partition with the FAT filesystem:
/sbin/fdisk -lu my_disk.img
which displays a result similar to:
Units = sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Device Boot Start End Blocks Id System my_disk.img1 * 32 511999 255984 6 FAT16
In the above result, note the start address by the number underneath "Start". E.g. 32 sectors.
Multiply it by 512 bytes. The result can be used with mount option -o offset= and with the -t option of the SYSLINUX installer.
In this example the respective commands would be:
mount -o loop,offset=16384 my_disk.img /mnt/my_disk_root
syslinux --directory /boot/syslinux/ -t 16384 --install my_disk.img
An example of disk image production is the Howto for hard disk images. It uses other means to apply the offset to mount, though. It lets losetup create a loop device for the image and another one for the partition in it. As always, the SYSLINUX installer operates on the partition device.